37 deg Bend for Ezirail 50mm Full Round (American Oak) D4VD02 This fitting may also be

This fitting may also be used without the small return part to secure certain other types of sheet material to tubes eg

often used between middle rail and uprights on level sites and often paired with type 101 or 104

Each kit comes complete with bolts and set screws

Diecast Zinc Alloy that has then been powdercoated in a Satin (Brushed) Gold finish (this is a very flat finish rather than being shiny)

37 deg Bend for Ezirail 50mm Full Round (American Oak) D4VD02 This fitting may also beWhere would you normally use a timber handrail fitting? As part of a handrail on a staircase when needing to change from the horizontal plane to a 37 degree incline decline (most stairs are pitched at 37 degrees). What is it made out of? Sustainably sourced American (White) Oak. How do you fix it to the handrail? Drill the end of the handrail (with a 16mm drill bit), then using a 16mm multi groove dowel, glue the rail to the pre drilled bend. A small