Pay in 4 interest-free payments of $4.86 Learn more
Ships within 48 hours · Estimated delivery Aug 1 - Aug 6
This is the corner fitting for the traditional hip ended frame tent design
low-density polyethylene end plug and a swaged top with push button to connect to the upper pole section
They are commonly used on entrance marquees where water draining off the roof of of the main tent would normally fall in between its edge and the edge of an entrance marquee
With a header bar (sold separately) this door can also be utilized on most pole supported tents
JT Push Button Tool Festival This is the corner fittingThis tool is used to aid in the installation and removal of 3 8" Push Buttons inside the standard 1. 25" SCH40 steel pipe used for fittings. This tool would be commonly used to install and remove push buttons from Jumbotrac and Jumbotrac Lite fittings. This tool will also function to install and remove 1 4" push buttons in 1. 75" OD aluminum tubing. The specially designed "U" shaped end is used for pushing and turning the push button into position.
US$ 59.95
US$ 30.00
US$ 119.90
US$ 19.90
